Koi Search
   
 

Sequence F.A.Q.

Installation

Q: I just installed a new unit and when I turn it on, the motor makes a funny sound and doesn't come up to speed properly.

A: Check to make sure that the supply voltage matches the voltage the motor is set for. In other words, if your motor is wired according to 230 Volt connections, then your supply line must also be 230Volts.

Q: We have a new system and just installed the pump and its making a noisy sound, sort of like its pumping sand.

A: If the motor connections are properly set, then you need to check the actual voltage supplied at the motor. It is best to do this with the motor, and any other lights or equipment that share that circuit, running. Using a voltmeter, check the voltage across Line 1 and Line 2 leads. It should be with in 5% of the nominal 115 or 230V. It the voltage is low, correct the problem before trying to operate the pump.  With the pump running, slowly close down your valve on the discharge side of the pump. If the noise goes away, then you were hearing cavitation. Cavitation is caused when the pump isn't getting water re-supplied quickly enough. To remedy this, you need to:

  1. Reduce the output by partially closing a valve on the discharge, until you reach a point where the cavitation stops.
  2. Increase the diameter of pipe on the suction of the pump.
  3. Shorten the length of the pipe on the suction of the pump.
  4. Reduce the numbers of elbows on the suction of the pump.
  5. Lower the elevation of the pump.

Any one or combination of the above changes will help eliminate cavitation.

Q: Pump Loses Prime

  1. Defective check or foot valve.
  2. Inlet line air leakage.
  3. Seal leaking. 
  4. Fluid supply low.

Flow Problems

Pump Operates With Little Or No Flow

  1. Check to insure that pump is primed.
  2. Check for leaking seal.
  3. Improper line voltage to motor or incorrect rotation.
  4. Check for clogged inlet port and/or impeller.
  5. Defective check or foot valve.
  6. Check inlet lines for leakage, either fluid or air.

Motor problems

Motor Will Not Rotate

  1. Check for proper electrical connections to motor.
  2. Check main power box for blown fuse, etc.
  3. Check thermal overload on motor.

Motor Hums Or Will Not Rotate At Correct Speed

  1. Check for proper electrical connections to motor and proper cord size and length.
  2. Check for foreign material inside pump.
  3. Remove bracket and check for impeller rotation without excessive resistance.
  4. Remove pump and check shaft rotation for excessive bearing noise.
  5. Have authorized serviceman check start switch and/or condenser.

Motor Or Pump Overheats

  1. Check for proper line voltage and phase, also proper motor wiring.
  2. Binding motor shaft or pump parts.
  3. Inadequate ventilation.
  4. Fluid being pumped should not exceed 194°F (90°C) for extended periods of time.

 

 

Back to the Sequence Information page.